[. . . ] This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring the correct disposal of this appliance, you can help prevent potentially negative consequences for the environment and the health of persons. The symbol on the appliance, or on the accompanying documents, indicates that this appliance should not be treated as domestic waste but must be taken to a special collection centre for the recycling of electrical and electronic equipment. When scrapping the appliance, make it unusable by cutting off the power cable and removing the doors and shelves so that children cannot easily climb inside and become trapped. [. . . ] • The refrigerator accepts light bulbs with a bayonet type mount. • The ice/water dispenser light bulb has a standard screw type mount. Replace the lamp with one of the same type, available from the Aftersales Service or from authorised dealers. 16 GUIDE TO THE INSIDE PARTS FRESH FOOD COMPARTMENT (if available) The fresh food compartment has a tilting movement that facilitates the introduction and the removal of food. Open the Fresh Food compartment by pressing one of the buttons (1), while at the same time pulling the compartment as far as it will go. To remove the Fresh Food compartment proceed as above instructions and then lightly rotate and remove the compartment from it seat (2). To replace the compartment insert the external lateral guides of the container (3a) in their seats near the retaining pins (3b). 3a Note: Do not store any food in metal or sharp packaging inside the fresh food compartment as this could damage the surface of the compartment itself. the drawer will come off the runners and can be pulled out further; 4. to remove it completely, the drawer must be turned: front end up, rear end down. Loading procedure Maximum storage capacity can be obtained by removing the two bottom drawers/baskets from the freezer compartment. Make sure that the air vents are not obstructed by the food (this applies to units with capacity lower than 715 litres). Meat drawer temperature control device • The cold air is conveyed inside the meat drawer through an opening between the refrigerator compartment and the freezer compartment. In this way the temperature inside the meat drawer is kept lower than the rest of the refrigerator. • To store vegetables in the meat drawer, shift the control device all the way to the left, to the vegetables setting. Crisper moisture control device • The level of humidity inside the crisper can be adjusted by moving the slider in the desired position. • By moving the slider to the far right, humidity will be eliminated from the compartment. This setting is better for preserving fruits and vegetables with skin. • By moving the slider to the far left, humidity is maintained inside the compartment. This setting is better for preserving leaf vegetables. 3b 17 USING THE ICE AND WATER DISPENSER (if available) First use When the ice and water dispenser is used for the first time, the first ice cubes and water coming out of the dispenser may have an unpleasant taste and should therefore be discarded. Pressing hard will not result in faster dispensing or greater quantities. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass. Do not use fragile glasses. USING THE AUTOMATIC ICE-MAKER (if available) After switching on the refrigerator, it usually takes overnight for the first ice cubes to form. When selecting crushed ice, the cubes are crushed just before being dispensed, therefore the crushed ice may come out with a slight delay. [. . . ] Ordering replacement filters To order more water filter cartridges, please contact your After-sales Service. 1 2 3 4 5 AFTER-SALES SERVICE Before contacting the After-sales Service: Switch the appliance on again to see if the problem has been solved. If it has not, switch off the appliance again and repeat the operation after one hour. If your appliance still does not work properly after carrying out the checks listed in the troubleshooting guide and switching the appliance on again, contact the After-sales Service, clearly explaining the problem and specifying: • the type of fault, • the model, • the type and serial number of the appliance (given on the rating plate), • the Service number (the number after the word SERVICE on the rating plate inside the appliance). Note: If removal of appliance door is carried out by the After-sales Service it is not covered by the warranty. 21 ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. [. . . ]